SONY - KDL-V26A11E _ KDL-V32A11E - FLAT PANEL CTV – SERVICE POSITION
Lay TV set flat and remove the rear cover. Ensure screen is
shielded from damage by lying on protective material.
Disassemble the foot from the TV set by removing the four
screws circled.
Remove the main brackets.
Disconnect the harnesses connected to boards beneath the
main shield case (NP1, BL and N boards). Remove the main shield case.
Remove the NP1, BL and N boards.
Remove the A1board (KDL-V26A11E) or the A2 board
(KDL-V32A11E).
Re-fit the foot to the TV set and place the set back in a
vertical position. Place a support of approx 35cm high as close as possible to
the TV set as shown below.
Arrange the removed circuit boards as shown in the picture.
Reconnect the interconnecting harnesses to the circuit boards.
Note: Two new cables are needed to connect the boards in the
service position
Cable 1: Part Number: 9-948-020-73 G2 board CN6200, CN6203
to NP1 board CN5801, CN5802
Cable 2: Part Number: 9-948-020-72 N board CN3402 to A1/A2
board CN5105
Using the IF board the A1 board can be mounted vertically as
shown in the picture below.
CLICK ON THE PICTURES TO MAGNIFY
No comments:
Post a Comment
WhatsApp +923139292880
Note: Only a member of this blog may post a comment.