Wednesday, December 11, 2013

SOny Wega2

Cont:-

Section –2

       We have already reached half the way by troubleshooting power supply section.  We have found that here is no fault with mains ON/OFF switch, Rectifier Bridge, switching regulator IC, posistor.  The main component to check further is (R610 – 33Kohms 3W) resistor, which supplies voltage to the internal circuits of the switching IC.  This is one among the important test point.  Check the voltage at (Pin-4) of regulator IC.  If there is no voltage, check this resistor for open.  If it is found OK, check the zener diode (D603) for short.  Replace it, it is best.  If switching regulator IC found shorted, you have to check all the components on the primary side of the SMPS power supply.  Even a small ceramic capacitor can cause severe trouble to switching power section.

      It is recommended to use a 100W filament type bulb at the secondary [135] VDC line, after disconnecting (R502), the serial resistor connected to LOT power supply.  You can reconnect this after finishing the power supply work. When a set comes to you for repair, with dead power regulator section, with shorted switching IC [STR F6707A], be very careful, and check all other components, for any short, open or any other trouble.  Replace these components, even if they are found good. [C610, D605, R608, R605, D603&C606]. If power regulation is found poor, check and replace (IC602 – SE135N) and optocoupler (PH600).  If STR are is found shorted, you have to replace all the above mentioned components, otherwise the newly replaced STR may get fail, as soon as you switch ON the set. 
Check all the solder terminals of SMPS transformer, and other components for loose soldering.  This is the main fault for most of the Sony set.  Resolder all the suspected solder points by applying a little more solder, without making any solder bridge short in between adjacent solder points.
 
C 623 & C 602 are very important capacitors, even though they are very small.  Replace both of them with same value.

Will come with other faults to this TV soon.

No comments:

Post a Comment

WhatsApp +923139292880

Note: Only a member of this blog may post a comment.

Haier LE58K6600UG Software

  Haier LE58K6600UG Software  Whatsapp me at +923139292880 Haier Tv Software Solution Available